Логические - Сигнальные переключатели, мультиплексоры, декодеры

2-Input Digital Multiplexer

Quad 2-Input Multiplexers

These monolithic data selectors/multiplexers contain full on-chip binary decoding to select one-of-eight data sources and feature a strobe-controlled three-state output. The strobe must be at a low logic level to enable these devices. The three-state outputs permit a number of outputs to be connected to a common bus. When the strobe input is high, both outputs are in a high-impedance state in which both the upper and lower transistors of each totem-pole output are off, and the output neither drives nor loads the bus significantly. When the strobe is low, the outputs are activated and operate as standard TTL totem-pole outputs. To minimize the possibility that two outputs will attempt to take a common bus to opposite logic levels, the output control circuitry is designed so that the average output disable time is shorter than the average output enable time. The SN54251 and SN74251 have output clamp diodes to attenuate reflections on the bus line.

SRAM Nonvolatile Controller IC for 1 SRAM Bank 8-SOIC 0 to 70

8-Input Digital Multiplexer

DUAL 2-LINE TO 4-LINE DECODERS/DEMULTIPLEXERS

2-Input Digital Multiplexer

1-OF-8 FET MULTIPLEXER/DEMULTIPLEXER

Logic IC

Zener Diode 225 mW 8.2 V ±2%SOT-23; Package: SOT-23 TO-236 3 LEAD; No of Pins: 3; Container: Tape and Reel; Qty per Container: 3000

3-STATE Quad 2-Data Selectors/Multiplexers

Bus Switch

3-to-8 line decoder, demultiplexer with address latches

Bus Switch

Bus Switch

4-Bit Bus Switch

IC 10BIT BUS SWITCH 24TSSOP

Dual 4-Input Multiplexer with 3-STATE Outputs

QUADRUPLE 2-LINE TO 1-LINE DATA SELECTORS/MULTIPLEXERS